“How do I create a 3D Model with a 3D Laser Scanner?”
As of late I have been asked this question a lot. So I thought for this month’s “Trainer's Corner” I would try to convey the answer. I should point out that the following is an overview and not a highly detailed step by step process. There are a lot of factors that will dictate such an undertaking; detail level, scanning equipment, point cloud registration software, as well as CAD software to name a few. Not knowing what your flavour of each is, I thought it best to keep this rather light.
Also, before I get started I’d like to point out that the aforementioned question is a bit of a trick question. I do not know of a 3D laser scanner out there that will create a 3D CAD model. If there is please let me know as it will greatly streamline the following process. For the novice, what the 3D Laser Scanner actually creates is a point cloud that we can use to create a 3D CAD model. As of yet I don’t believe there is an “easy button”.
This particular project as you will see is that of an Olympic swimming pool building. We scanned it with the Trimble TX5 Laser Scanner with the intent of creating a 3D CAD model, with the main focus being on the walls, ceiling and structure.
Our first step was to make a site visit and start scanning. Setting up the scanner in six locations we were able to collect the necessary number of points for the detail level we were looking for. Each scan took approximately six minutes and because of the number of flat surfaces, targets were not used. I need to point out that this is more of an exception to the rule vs. the norm. The majority of the time you will be placing spherical targets as well as checkerboard targets to help your registration software “stitch” the multiple scans together.
Here is a floor plan shot of the building with the scan stations visible to give you a better idea of the setting out.
With our scans complete our site visit was done and it was back to the office to start registering our scans.
There are several point cloud registration software options out there. Ours is RealWorks and it gives you a lot of flexibility. The registration process is simple with RealWorks:
- Launch the software
- Import the files from the scanner
The size of each scan and the horsepower of your computer will determine how long this takes, usually a few minutes each.
This is a picture of the registered point cloud.
With a registered point cloud you can use RealWorks to make your task more manageable. Dumping the entire cloud into your 3D modelling software in most cases is not possible due to the sheer size of the file. I can use the software to segment the cloud into more bite size pieces and easier for my CAD modelling software to digest. This takes only minutes with the included tools in RealWorks.
With specific sections cut out of the model I can import them into my 3D modelling software and start modelling walls, doors, windows, structure, etc. Modelling time can vary greatly on how much or how little detail you are trying to get to out of the scan. The advantage of having the cut sections from the registered point cloud is that you have a template to follow. I typically start with the easier items first; walls, floor and ceiling. I then go after, in this case, the structural system. The trusses were modeled once and then copied and pasted.
Once the bulk of the walls and structure was complete I was able to create some cut sections and a ceiling plan.
Again, this was a rather broad stroke as far as detail is concerned. However the overall time spent on this project was not much at all compared to conventional methods of collecting as-built data and then modelling from that. I think it’s also important to note that there was only one site visit, with the laser scanner, any and all information we needed was collected in one trip.
The time breakdown is as follows:
- Approximate Building size: 30,000 sq.
- Scan Time including setup: 1 hour
- Registration, Segmenting, Sectioning: 45 minutes
- Exporting: 10 minutes
- Modelling in Revit: 27 hours
- Total time investment: Just under 30 hours